Fatigue and damage accumulation of veneer porcelain pressed on Y-TZP☆

Abstract 

Objectives

This study compared the reliability and fracture patterns of zirconia cores veneered with pressable porcelain submitted to either axial or off-axis sliding contact fatigue.

Methods

Forty-two Y-TZP plates (12mm×12mm×0.5mm) veneered with pressable porcelain (12mm×12mm×1.2mm) and adhesively luted to water aged composite resin blocks (12mm×12mm×4mm) were stored in water at least 7 days prior to testing. Profiles for step-stress fatigue (ratio 3:2:1) were determined from single load to fracture tests (n=3). Fatigue loading was delivered on specimen either on axial (n=18) or off-axis 30° angulation (n=18) to simulate posterior tooth cusp inclination creating a 0.7mm slide. Single load and fatigue tests utilized a 6.25mm diameter WC indenter. Specimens were inspected by means of polarized-light microscope and SEM. Use level probability Weibull curves were plotted with 2-sided 90% confidence bounds (CB) and reliability for missions of 50,000 cycles at 200N (90% CB) were calculated.

Results

The calculated Weibull Beta was 3.34 and 2.47 for axial and off-axis groups, respectively, indicating that fatigue accelerated failure in both loading modes. The reliability data for a mission of 50,000 cycles at 200N load with 90% CB indicates no difference between loading groups. Deep penetrating cone cracks reaching the core–veneer interface were observed in both groups. Partial cones due to the sliding component were observed along with the cone cracking for the off-axis group. No Y-TZP core fractures were observed.

Conclusions

Reliability was not significantly different between axial and off-axis mouth-motion fatigued pressed over Y-TZP cores, but incorporation of sliding resulted in more aggressive damage on the veneer.

Keywords: Y-TZP, Step-stress fatigue, Pressable porcelain, All-ceramics, Reliability, Zirconia