Mineral density of hypomineralised enamel

Abstract 

Objectives

To characterize molar–incisor hypomineralisation (MIH) defects of different severities quantitatively and qualitatively using X-ray microtomography (XMT) and to measure the range of reduction in mineral density (MD) of MIH enamel compared with the normal range.

Methods

Ten sound teeth and ten MIH teeth were scanned using a commercial XMT system. Four hydroxyapatite phantoms of different densities were used as calibration standards with each scan. A calibration equation derived from the phantoms with each tooth was used for MD calibration. MD was traced from the cementum–enamel junction (CEJ) to the cusp tip and from the dentine–enamel junction (DEJ) to the outer enamel surface.

Results

In sound teeth, MD increased from CEJ to cusp/incisal tip, while in MIH teeth MD dropped from the CEJ to the occlusal region, then increased again at the cusp tip. MD was highest midway between DEJ and outer enamel in sound teeth. In MIH, enamel showed normal thickness and MD was highest near the DEJ and then decreased towards the outer enamel. MD of MIH enamel was on average about 19% lower than sound enamel. The MIH defects seemed to follow the incremental lines of enamel formation.

Conclusions

MIH defects are hypomineralised defects of different severities that follow the natural incremental lines of enamel formation. Cuspal areas are usually only mildly affected and cervical enamel always appears to be sound.

Keywords: Molar–incisor hypomineralisation, X-ray microtomography, Mineral density