Journal of Dentistry
Volume 36, Issue 6 , Pages 450-455 , June 2008

Nanoparticle-reinforced resin-based dental composites

  • Yang Xia

      Affiliations

    • Institute of Stomatology, Nanjing Medical University, 136 HanZhong Road, Nanjing 210029, People's Republic of China
    • ,
  • Feimin Zhang

      Affiliations

    • Institute of Stomatology, Nanjing Medical University, 136 HanZhong Road, Nanjing 210029, People's Republic of China
    • Corresponding Author InformationCorresponding author. Tel.: +86 13801589779; fax: +86 2586516414.
    • ,
  • Haifeng Xie

      Affiliations

    • Institute of Stomatology, Nanjing Medical University, 136 HanZhong Road, Nanjing 210029, People's Republic of China
    • ,
  • Ning Gu

      Affiliations

    • Jiangsu Laboratory for Biomaterials and Devices, State Key Laboratory of Bioelectronics, Southeast University, 2 SiPaiLou Road, Nanjing 210096, People's Republic of China

Received 8 December 2007 ,Revised 1 March 2008 ,Accepted 4 March 2008.

References 

  1. Ruddell DE, Maloney MM, Thompson JY. Effect of novel filler particles on the mechanical and wear properties of dental composites. Dental Material. 2002;18:72–80
  2. Xu HHK, Quinn JB, Smith DT, Antonucci JM, Schumacher GE, Eichmiller FC. Dental resin composites containing silica-fused whiskers––effects of whisker-to-silica ratio on fracture toughness and indentation properties. Biomaterials. 2002;23:735–742
  3. Taylor DF, Kalachandra S, Sankarapandian M, McGrath JE. Relationship between filler and matrix resin characteristic sand the properties of uncured composite pastes. Biomaterials. 1998;19:197–204
  4. Chung CM, Kim JG, Kim MS, Kim KM, Kim KN. Development of a new photo curable composite resin with reduced curing shrinkage. Dental Material. 2002;18:174–178
  5. Atai M, Nekoomanesh M, Hashemi SA, Amani S. Physical and mechanical properties of an experimental dental composite based on a new monomer. Dental Material. 2004;20:663–668
  6. Lu H, Stansbury JW, Nie J, Berchtold KA, Bowman CN. Development of highly reactive mono-(meth) acrylates as reactive diluents for dimethacrylate-based dental resin systems. Biomaterials. 2005;26:1329–1336
  7. Ikejima I, Nomoto R, McCabe JF. Shear punch strength and flexural strength of model composites with varying filler volume fraction, particle size and silanation. Dental Material. 2003;19:206–211
  8. Ferracane JL, Condon JR. Post-cure heat treatments for composites: properties and fractography. Dental Material. 1992;8:290–295
  9. Loza-Herrero MA, Rueggeberg FA, Caughman WF, Schuster GS, Lefebvre CA, Gardner FM. Effect of heating delay on conversion and strength of a post-cured resin composite. Journal of Dental Research. 1998;77:426–431
  10. Wendt SL. The effect of heat as a secondary cure upon the physical properties of three composite resins: I. Diametral tensile strength, compressive strength and marginal dimensional stability. Quintessence International. 1987;18:265–271
  11. Asmussen E, Peutzfeldt A. Mechanical properties of heattreated restorative resin for use in the inlay/onlay technique. Scandinavian Journal of Dental Research. 1990;98:564–567
  12. Krause WR, Park SH, Straup RA. Mechanical properties of Bis-GMA resin short glass fiber composites. Journal Biomedical Material Research. 1989;23:1195–1211
  13. Bayne SC, Thompson JY. Mechanical property analysis of two admixed PRIMM-modified commercial dental composites. Academy Dental Material Transaction. 1996;9:238
  14. Zhang Rb, Gao L. Effect of peptization on phase transformation of TiO2 nanoparticles. Material Research Bulletin. 2001;36:1957–1965
  15. Yang J, Mei S, Ferreira JMF. Hydrothemal synthesis of nanosized titania powders: influence of tetraalkyl ammonium hydroxides on particle characteristic. Journal of American Ceramic Society. 2001;84:1696–1706
  16. Wetzel B, Rosso P, Haupert F, Friedrich K. Epoxy nanocomposites––fracture and toughening mechanisms. Engineering Fracture Mechanics. 2006;73:2375–2398
  17. Navio A, Cilon G. Iron-doped titania semiconductor powders prepared by a sol-gel method (Part I): synthesis and characterization. Applied Catalysis A: General. 1999;177:111–120
  18. Mohsen NM, Craig RG. Effect of silanation of fillers on their dispersability by monomer systems. Journal of Oral Rehabilitation. 1995;22:183–189
  19. Wang JW, Ploehn H. Dynamic mechanical analysis of the effect of water on glass bead–epoxy composites. Journal of Applied Polymer Science. 1996;59:345–357
  20. Sakaguchi RL, Cross M, Douglas WH. A simple model of crack propagation in dental restorations. Dental Material. 1992;8:131–136
  21. Fadeev AY, Helmy R, Marcinko S. Self-Assembled Monolayers of Organosilicon Hydrides Supported on Titanium, Zirconium, and Hafnium Dioxides. Langmuir. 2002;18:7521–7529
  22. Condon JR, Ferraccane JL. Assessing the effect of composite formulation on polymerization. Journal of American Dental Association. 2000;131:497–503
  23. Gao L, Sun J, Liu YQ. The disperation and surface modification of nano particles. Beijing: Publishing House of Chemical Industry; 2003;
  24. Mitra SB, Wu D, Holmes BN. An application of nanotechnology in advanced dental material. Journal of American Dental Association. 2003;134:1382–1390
  25. Terry DA. Direct applications of a nanocomposite resin system: Part 1-The evolution of contemporary composite materials. Practical Procedure & Aesthetic Dentistry. 2004;16:417–422

PII: S0300-5712(08)00077-8

doi: 10.1016/j.jdent.2008.03.001

Journal of Dentistry
Volume 36, Issue 6 , Pages 450-455 , June 2008

Article Tools

* Image Usage & Resolution